AUS BIZ BENCHMARKS

ATO benchmark, 2023-24 financial year

ATO small business benchmarks for carpentry services

The ATO's 2023-24 benchmark for carpentry services puts total expenses at 46% to 66% of turnover for a business turning over A$110,001 to A$400,000. The average for that band is 56%. Below that, in the A$50,000 to A$110,000 band, the range is 32% to 50%; above it, for turnover of more than A$400,000, it is 76% to 87%.

The carpentry services ranges are drawn from 2023-24 tax returns and were the latest available when this page was compiled in November 2026.

1.0 Benchmark ranges by turnover band

Each cell shows the share of annual turnover, GST excluded, that the ATO found typical for that expense among carpentry services businesses, and the column to read is the one that matches your own turnover.

Table 1 ATO benchmark ranges for carpentry services, 2023-24
Ratio to turnoverA$50,000 to A$110,000A$110,001 to A$400,000More than A$400,000
Total expenses (key)32% to 50%46% to 66%76% to 87%
Average total expenses41%56%81%
Labour24% to 39%21% to 35%27% to 43%
Motor vehicle expenses8% to 12%5% to 8%2% to 4%

Source: ATO small business benchmarks, 2023-24. Blank ratios are not published for this industry.

Figure 1 Total expenses as a share of turnover by turnover band, carpentry services, 2023-24
0%25%50%75%100%A$50,000 to A$110,00032% to 50%A$110,001 to A$400,00046% to 66%More than A$400,00076% to 87%

Blue bar: published range. Gold marker: band average where the ATO gives one.

1.1 Who the ATO counts as carpentry services

The ATO places a business in the carpentry services benchmark using its business industry code and keywords in the trading name and activity description on the return, and describes the group this way:

Businesses in this industry provide carpentry services in the construction, commercial and domestic markets. This can include formwork, installing doors and partitions, and helping with house construction and renovations.

These benchmarks don't apply to cabinet makers .

2.0 What each ratio means for carpentry services

Total expenses is the broadest of the ratios, and in the carpentry services category a business turning over A$255,000 would sit inside the range with expenses of A$117,300 to A$168,300, which is 46% to 66% of sales, and the ATO excludes payments to associated persons before it divides.

The band averages for carpentry services run 41%, then 56%, then 81% as turnover rises, a change of 40 percentage points from the lowest band to the highest. A gap that wide between the smallest and largest carpentry services businesses usually reflects staffing: an owner working alone does not expense their own time, while a larger business pays wages for the same work. At the middle band average of 56%, a carpentry services business has about 44 cents in each dollar of sales left before the owner's own pay and income tax, or roughly A$112,200 on A$255,000 of turnover.

There is no cost of sales ratio in the carpentry services benchmark; total expenses is the key ratio, which is the usual arrangement where an industry sells time and skill more than stock.

The carpentry services labour range, which counts salary and wages plus contractor, sub-contractor and commission payments less anything paid to associated persons, is 21% to 35% in the A$110,001 to A$400,000 band, or A$53,550 to A$89,250 a year on A$255,000 of turnover. Across bands the labour share for carpentry services is highest for turnover of more than A$400,000 (27% to 43%), and its mid-band midpoint ranks 16th of the 50 industries with a labour ratio.

For vehicles, the carpentry services benchmark is 5% to 8% of turnover in the A$110,001 to A$400,000 band (A$12,750 to A$20,400 on A$255,000), and 8% to 12% in the lowest band.

3.0 How to work out your own ratios

For carpentry services, as for every benchmark, the sum is the expense divided by turnover excluding GST, times 100, and the figures to use are those on the business schedule of the tax return, because the ATO builds the ranges from return labels and not from bank statements.

Worked example, carpentry services, turnover A$255,000
Total expenses claimed (less any payments to associated persons): A$143,000
A$143,000 ÷ A$255,000 × 100 = 56.1%
Published range for A$110,001 to A$400,000: 46% to 66%. Result: inside the range.

Two adjustments matter when a carpentry services business runs this check: turnover means sales of goods and services (the A$255,000 in the example), so interest, asset sales and government payments stay out unless they are most of the income. And if you are a sole trader, your own drawings are not an expense, which is why a small carpentry services business can show a ratio well under the larger bands.

4.0 If your figure falls outside the range

A total expenses ratio above 66% for a carpentry services business in this band means expenses are high for the sales reported, and the ATO lists the ordinary causes as wastage, stock taken for private use, paying more for inputs than competitors, low mark-up, and sales that were not all recorded. Because total expenses is the key ratio for carpentry services, it is also the one the ATO uses to pick out returns where income may be under-reported, so a figure well above 66% is the result most likely to draw a question.

Sitting below 46% usually just means a carpentry services business is more profitable than most of its peers, or that some deductible costs were missed. Keep the width of the range in mind: the ATO draws it around the 30% of carpentry services businesses closest to the band average, so most of the population sits outside it on one side or the other.

The ATO says it never uses a benchmark in isolation when deciding to review a business, and an unusual model (a second site, a wholesale sideline, a new fit-out) is a legitimate reason for a carpentry services return to differ from its peers.

5.0 How the total expenses range has moved

Between 2021-22 and 2023-24 the total expenses range for carpentry services in the middle band went from 52% to 46% at the bottom (down 6 points) and went from 71% to 66% at the top (down 5 points). A shift of that size is worth knowing about if you last checked a carpentry services business against an older table.

Figure 2 Total expenses to turnover, middle band, carpentry services, by financial year
0%25%50%75%100%2021-2252% to 71%2022-2349% to 69%2023-2446% to 66%

6.0 Industries with similar ratios

Ranked by the midpoint of the total expenses range in the middle band, the carpentry services benchmark is 92nd of the 100 benchmark industries, where 1st carries the heaviest expense load; its closest neighbours on that measure are listed below.

Table 2 Benchmark industries nearest to carpentry services on total expenses
IndustryKey ratioTotal expensesBand
Architectural servicestotal expenses40% to 65%A$220,001 to A$400,000
Timber floor sandingtotal expenses44% to 62%A$100,001 to A$200,000
Pest control servicestotal expenses45% to 66%A$150,001 to A$400,000
Delivery servicestotal expenses48% to 66%A$90,001 to A$210,000
Cleaning services (building and other industrial)total expenses46% to 69%A$115,001 to A$250,000
Bricklaying servicestotal expenses51% to 68%A$150,001 to A$350,000

To put a number on the carpentry services category, the nearest ABS industry class is Carpentry Services (ANZSIC 3242), with 53,883 businesses operating at June 2025. That match is ours, and the ABS class is broader than the ATO's carpentry services group, so read the two sets of figures side by side, not as one population.

7.0 Questions on these figures

7.1 What is the ATO benchmark for carpentry services with turnover of more than A$400,000?

For more than A$400,000 the total expenses range is 76% to 87% of turnover (average 81%), based on 2023-24 returns.

7.2 How much of turnover do carpentry services businesses spend on labour?

The ATO labour range for carpentry services is 24% to 39% for A$50,000 to A$110,000; 21% to 35% for A$110,001 to A$400,000; 27% to 43% for more than A$400,000.

7.3 Did the carpentry services benchmark change between 2022-23 and 2023-24?

In the middle band the total expenses range was 49% to 69% in 2022-23 and 46% to 66% in 2023-24.

7.4 Which ratio does the ATO treat as the key benchmark for carpentry services?

Total expenses to turnover is the key ratio for carpentry services, the one the ATO regards as the best predictor of turnover in the industry.

8.0 Sources

  1. Australian Taxation Office, Small business benchmarks: Carpentry services, 2023-24 financial year. ato.gov.au Licence: ATO copyright notice permits reuse with attribution.
  2. Australian Taxation Office, Small Business Benchmarks data files, 2021-22 to 2023-24, data.gov.au. data.gov.au Licence: CC BY 2.5 AU.
  3. Australian Bureau of Statistics, Counts of Australian Businesses, including Entries and Exits, July 2021 to June 2025, data cubes 1 to 5 (detail released December 2025). abs.gov.au Licence: CC BY 4.0.
  4. Australian Taxation Office, Small business benchmarks methodology and ratio calculations. ato.gov.au
  5. Australian Taxation Office, What it means to be outside the benchmark range. ato.gov.au
  6. Australian Taxation Office, How we use business performance benchmarks. ato.gov.au

Compiled November 2026. Figures are reproduced or calculated from the sources listed; the publishing agency is the authority if anything here differs from its own release. Report an error.